Manually interfering with the movement of cellular shades may cause the bottom rail to become uneven.
To restore the shades to their proper condition, here are two effective solutions:
Method 1: Simple Manual Adjustment
-
Lower the Shades
Use the remote control to lower the cellular shades to their lowest position, fully extending them. -
Adjust the Bottom Edge
Locate the side of the bottom edge that is higher, and gently pull it down until both sides are level. -
Raise the Shades
Use the remote control to fully raise the shades to their highest position, retracting them completely. -
Repeat the Process
Repeat the steps above about three times. This method is suitable for minor tilting issues and typically resolves the problem.
Method 2: Advanced Adjustment (If Method 1 Does Not Work)
-
Remove the Shades
Fully raise the shades, then carefully remove them from the mounting brackets. -
Inspect the Cord Alignment
Check the spools inside the shades to ensure the cords are properly aligned. If the cords are misaligned or too tightly wrapped, adjustments will be necessary.
-
Reset the Bottom Limit
- Use the remote control to move the shades to the current bottom limit position.
- Press and hold the "UP" and "DOWN" buttons on the remote control simultaneously for 2 seconds. The shades will jog up and down once.
- Slowly lower the shades using the remote control until there is only one loop of cord remaining on the spool.
-
Ensure the Cord is Aligned
Fully raise the shades using the remote control, ensuring the cords are evenly aligned on the spools. During this process, keep the shades level to avoid further misalignment and ensure the bottom edge does not touch the floor. -
Reinstall the Shades and Restore the Bottom Limit
- Reinstall the shades onto the mounting brackets.
- Use the remote control to move the shades to the original bottom limit position.
- Press and hold the "STOP" button on the remote control for 2 seconds. The shades will jog up and down once, completing the bottom limit setting.